Issue in calls between tandberg E95 MXP and GS/HDX device
Am facing an issue like the below.
All my video endpoints were registered on DMA (version 6.4.1_P2). My GS 500 version is 6.1 & HDX 4000 version is 3.1.11_1 and my tandberg E95 MXP version is f9.3.3.
My video environment is completely based on SIP TLS. When am dialing from my tandberg device to GS 500/HDX 4000 calls were connecting properly, but when i dialed from GS/HDX calls were not able to reach tandberg E95 device.
When i go through the call logs in call history, am able to see an error "socket error: Received fatal alert: handshake_failure".
NIM-PVDM is the Next-generation digital signal processor (DSP) module with an onboard DSP daughter card which eliminates the need to procure an additional T1/E1 NIM card in order to utilize a PVDM4 chip for IP media services. This module enables the new C...
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...