cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1189
Views
0
Helpful
3
Replies
paul alves
Enthusiast

Jabber (movi) users log into VCS/TMS with any password successfully!!

Hi All,

I'm having this strange problem.

I've configured TMS for extended provisioning, but I just noticed something very strange.

When I log in as any user, when I put any password in there I can successfully log in as the user.

I tried off the wall passwords on multiple users, and they continue to succesfully log in regardless of password!!

Anyone have any ideas on why this would be?

These users were manually added.

thanks

Paul

1 ACCEPTED SOLUTION

Accepted Solutions

I've had the same results as well, I found it to be the that the Default Zone was set to "Treat as Authenticated". it should either be "Do not check credentials" or "Check credentials".

Sent from Cisco Technical Support iPad App

View solution in original post

3 REPLIES 3

I've had the same results as well, I found it to be the that the Default Zone was set to "Treat as Authenticated". it should either be "Do not check credentials" or "Check credentials".

Sent from Cisco Technical Support iPad App

Justin Ferello
Contributor

Paul,

Also make sure that in TMS under the TMS Agent tab for the VCS that the 'Authentication Scheme' is set to 'Digest' and not 'None'.

Thanks,

Justin

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ
Jens Didriksen
Engager

Take a look at the "Authentication of devices and accounts" section found here:

http://www.cisco.com/en/US/partner/products/ps11337/products_installation_and_configuration_guides_list.html

and choose the document which corresponds to software version of your VCS.

/jens

Please rate replies and mark question(s) as "answered" if applicable.
Create
Recognize Your Peers
Content for Community-Ad