cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
488
Views
0
Helpful
4
Replies
Highlighted
Rising star

Macros and Cloud Registered Devices

I was thinking about creating a macro to prompt a user for a 5 digit number, then to append @acme.com to it and place a SIP call. 

 

So, two questions:

 

1) Are macros supported on cloud (webex)  registered room devices, eg Roomkit mini?

 

2) is what I’m asking possible?

 

thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Hi
Yes it should be possible. You need to create a user to allow access to the cloud registered endpoint. See these links
Good training material on customisation here https://developer.cisco.com/docs/prog-coe_resources/#!focused-learning/collaboration
Macro samples here https://github.com/CiscoDevNet/roomdevices-macros-samples

Thanks
ashish


Response Signature


View solution in original post

4 REPLIES 4
Highlighted
Cisco Employee

Hi
Yes it should be possible. You need to create a user to allow access to the cloud registered endpoint. See these links
Good training material on customisation here https://developer.cisco.com/docs/prog-coe_resources/#!focused-learning/collaboration
Macro samples here https://github.com/CiscoDevNet/roomdevices-macros-samples

Thanks
ashish


Response Signature


View solution in original post

Highlighted

Thanks @Ashish Patel 

 

When you say ‘create a user’ do you mean create a local user on the device?

 

Also, it seems that the first link is broken? I get a 403 Forbidden error. 

 

Thoughts? 

Highlighted

Also, when I go to github, specifically the postman section:

 

https://github.com/CiscoDevNet/postman-xapi

 

it has a note regarding using admin user for on-prem vs integrator user for cloud registered. 

 

I was expecting a similar note or distinction for the macro use but do not see that. 

 

So, do I use an admin account for local macros?

 

 

 

Highlighted

I found the step by step intro which talks about setting up the integrator account. And specifically mentions on-prem vs. cloud registered. 

 

I think I’ll go through those. But if anyone has any pointers or gotchas they ran into, that would be great. 

 

This is the step-by-step I’m talking about. 

 

https://developer.cisco.com/learning/lab/collab-xapi-intro/step/1