Re: Manual adjustment of the camera speed possible by Cisco Webex Quad Camera?
If the camera is being controlled by an external controller, then you would likely need to change the command that it is issuing to the codec/camera.
When issuing an xCommand Camera Ramp command via the API, you can specify the PanSpeed, TiltSpeed and ZoomSpeed.
If you're just triggering Presets, then the camera should just jump from one to the other and the "speed" it changes cannot be altered - it just happens. As the camera has a 4K sensor, it's capturing the whole scene, the view you are seeing is a digital crop of this, so there is no "movement" between.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...