cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
550
Views
0
Helpful
1
Replies
Beginner

Maximum FXS ports on a 2801 router?

Hello all,

I have a client that currently has two 4 port FXS cards, VPN Module, and a T1 and the client would like to add 4 more ports. I do not believe the router can support it, but want to be sure. Here is the show version and the slots al lthe cards are in:

Cisco 2801 (revision 6.0) with 240640K/21504K bytes of memory.

Processor board ID XXXXXXXXX

2 FastEthernet interfaces

1 Serial interface

1 Virtual Private Network (VPN) Module

8 Voice FXS interfaces

1 DSP, 8 Voice resources

DRAM configuration is 64 bits wide with parity disabled.

191K bytes of NVRAM.

62720K bytes of ATA CompactFlash (Read/Write)

PVDM Slot 0: PVDM2-8

VIC Slot 0: VIC3-4FXS/DID

WIC/VIC/HWIC Slot 1: VIC3-4FXS/DID

WIC/VIC Slot 2: WIC-1DSU-T1-V2

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Maximum FXS ports on a 2801 router?

Yes, anotther VIC card can be added, but you will also need to upgrade PVDM2, becase the 8-channels currently installed is totally used by the existing 8 FXS ports.

View solution in original post

1 REPLY 1
Highlighted
Hall of Fame Master

Maximum FXS ports on a 2801 router?

Yes, anotther VIC card can be added, but you will also need to upgrade PVDM2, becase the 8-channels currently installed is totally used by the existing 8 FXS ports.

View solution in original post

CreatePlease to create content