We are currently experiencing difficulties with presentation on a conference using the MCU 4501. The presentation quality is not bad but also not great and when there is movement on the PC like a slide show or plainly moving of the mouse then there is a major lag on the far end side. Sometimes allot of the pixels dont even appear when the screen changes or if a slide changes on the PC giving the Presentation on the conference. We have tested this from multiple units using either edge 95 or mxp3000.
We are streaming the calls at 768kbps on each VC and the MCU quality is set to SD.
If we use an old ISDN MCU then the presentation goes through smoothly with no delay or bad quality images.
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...