cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
753
Views
0
Helpful
2
Replies
alberto.orden
Beginner

MX200 & EX90 Upgrade doubt TC4.2.1 to TC5.0.1

Hi to everyone,

I installed a CUCM 8.6.2 and have two endpoints MX200 and EX90, I download the software cmterm-tcnc5_0_1.cop for both devices because I saw that they came with TC4.2.1

How do I upgrade this sofware?

Best regards,

Alberto

2 REPLIES 2
Paulo Souza
Rising star

Friend,

First of all, you need upgrade the codec, but you don't need "cmterm-tcnc5_0_1.cop" to do that, you need download "TelePresence Software-TC5.0.1 (s52000tc5_0_1.pkg), then upload it to the codec and put the required release key (you can generated the key into cisco.com/go/license page). So, you codec shall be in the latest version.

Then you can go on and register your codec to CUCM. This archive "cmterm-tcnc5_0_1" must to be installed on CUCM.

Regards,

Paulo Souza

Paulo Souza Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".
Magnus Ohm
Cisco Employee

Hi

You upload the file that paulo mentioned through the webinterface of the codec. Here you also type the release key.

The file that contains tcnc (tc no crypto) in the filename are for countries like china that does not allow encryption. So download the other one that is not tcnc.

If it was not on intention of course.

/ magnus

Sent from Cisco Technical Support iPhone App

Create
Recognize Your Peers
Content for Community-Ad