12-17-2014 09:09 AM - edited 03-18-2019 03:48 AM
Hi there,
I want to make a demo with one MX300 G2 and MX200 G2 for a customer.
I want to use both endpoints in a standalone mode, the customer doesn't have any vcs or cucm. ( Point to point call);
I read in the following thread that i must use H323 to be able to make calls directly:
https://supportforums.cisco.com/discussion/12340271/cisco-mx300-tcs-standalone
Here are the settings for both devices:
-------------
IP address: 192.168.1.229
mask : /24
default GW: 192.168.1.250
h323 mode: Direct
H323 Alias E164 : 2003
H323 Alias ID: youssef.aoufi@company.com
Default call protocol: H323
-------------
IP address: 192.168.1.230
mask : /24
default GW: 192.168.1.250
h323 mode: Direct
H323 Alias E164 : 2004
H323 Alias ID: user.test@company.com
Default call protocol: H323
The main problem is that i don't know how to dial :
if i dial 2004 from the MX300 i receive the following message: cannot connect call
If i dial: user.test@company.com from the MX300 i receive the following message: cannot connect call
If i dial: 192.168.1.230 from the MX300 i receive the following message: cannot connect call
If i dial: 2004@192.168.1.230 from the MX300 i receive the following message: could not place call to sip:2004@192.168.1.230.
I think i am missing something.
Thank you in advance for your help
12-17-2014 10:07 AM
Hi there,
Issue resolved, The H323 mode was disabled on the MX300.
Regards
12-18-2014 12:38 AM
Hi,
good luck, are you planning to deploy vcs or cucm as call control ?
regards
Anas
12-18-2014 02:43 AM
Hi Anas,
Thank you :) We will deploy it in standalone mode waiting for the arrival of the CUCM.
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: