cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

112
Views
0
Helpful
2
Replies
Highlighted
Contributor

MX700 won't accept xCommand

I am working with a new MX700.  I have everything setup and I can send API commands through the codecs web interface with no issues.  The one that is not working is the command to turn on Intelligent Proximity: xConfiguration Experimental Byod Mode: On  

The one thing that is different that might be an issue is that we upgraded to 7.2.  But I haven't been able to verify that intelligent proximity won't be supported with 7.2.  There is no error message when you try and run it, the blue line goes full and just sits there.  Any help is appreciated.

 

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Have you tried going through

Have you tried going through the web interface here:  Configuration > System Configuration?  The experimental settings aren't visible, but you can search for "experimental" and they'll appear.

View solution in original post

2 REPLIES 2

Have you tried going through

Have you tried going through the web interface here:  Configuration > System Configuration?  The experimental settings aren't visible, but you can search for "experimental" and they'll appear.

View solution in original post

Contributor

That did the trick.  Thanks

That did the trick.  Thanks for the info.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here