ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
336
Views
0
Helpful
1
Replies
Highlighted
Beginner

neighbor VCSE's

All,

I am novice MCU operator. I received a request to neighbor my VCSE. My problem is that I do not know where to begin or how to do it. Where can I get instructions or directions on doing this?

R,

Greg Smith

Everyone's tags (6)
1 REPLY 1
Highlighted
Engager

neighbor VCSE's

Did you check out the VCS admin and deployment guides?

http://www.cisco.com/en/US/products/ps11337/prod_maintenance_guides_list.html

http://www.cisco.com/en/US/products/ps11337/products_installation_and_configuration_guides_list.html

Like the X7.2 admin guide:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/admin_guide/Cisco_VCS_Administrator_Guide_X7-2.pdf

and the basic vcs-c/e deployment guide:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Basic_Configuration_Control_with_Expressway_Deployment_Guide_X7-2.pdf

could be a good start for basic understanding.

Is this for some intra company setup or some external call flow?

In general for business to business setup I would prefer routing via the DNS zone, so a neighboring to a specific

external VCS is not necessary.

Why dont you start talking to the remote site which you should neighbor up with to give you some more information

why and how. If you trust them and they are knowledgable that might be the easiest way to go :-)

Please remember to rate helpful responses and identify

This widget could not be displayed.