No Http response after switching system connectivity to Reachable on LAN
After adding an MXP codec to my Network and editing the system settings in TMS I could not connect b/c it was preset to "Behind Firewall."
When I change the connectivity in TMS to Reachable on LAN i get a system status of No Http response. And then lose the ability to adjust system settings in TMS. Do i need to adjust the http and https ports? If so, I can't find where to do this in the codec settings nor in TMS.
I'm only new to troubleshooting Tandberg Codecs, and am more familiar with the Polycom environment.
Hi the connectivity is set to behind firewall since the ip that is configured on the endpoint does not match the ip of the packet source address that the tms receives. This means that there is natting going on somewhere. Communication is http/https.
And since tms is unable to reach it as "reachable on lan" it will turn to no http response.
I'm not saying that this is what is going on but its very likely based on your description. Purge the system from
Tms, Start a wireshark trace on the tms server, add the system, look at what ip the response from the endpoint is coming from. Does it match the endpoint ip?
In a Clustering over the WAN deployment, securing the ICCS (Intra-Cluster Communication Signaling) traversing the WAN can be a requirement. The IPSEC VPN Policy between nodes can be configured to secure the ICCS Traffic.To quickly verify that the IPSEC is...
Attracted by the concept of dial plan and the passion of writing, I launched a challenge to write a workbook with practical scenarios covering in details this concept, the result is a workbook with 30 practice labs treating many components such route patt...
Understanding Media Negociation in Interworking / Traversal Call : SIP <-> H323 through Expressway. Inside SDP and H245. Both signaling and Media goes through the Expressway so the IP address of expressway is offered to both SIP and H.323 endpoin...
Sometimes you troubleshoot the phone presence status issue, or you are wondering how the status is retrieved by IMP, the best place to start is to look at the SIP Publish message sent by the CUCM to IMP, Capture the SIP Publish message using wireshark, in...
The translation pattern is the most important tool in the Call Routing Process on Cisco Unified Communication manager.By definition a Translation Pattern is used to match the DIALED NUMBER (CALLED). After a match is found we perform a digits manipulation....