cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
340
Views
0
Helpful
1
Replies
Ravi Yadav
Enthusiast

precision 60 datasheet query

Hi All,

 

can someone comment on the datasheet  info:

 

IP network features
●DNS lookup for service configuration
●Date and Time support via NTP
●TCP/IP
●DHCP
Network interfaces
●One LAN/Ethernet (RJ-45) 10/100 Mbit
 
as per the connection Guide two  P60 camera are connected over port #2 and #3.
and if we need addition port we connect a switch to port #3  that means it not over the regular LAN.
 
Is the network feature info pointing towards gathering this info from Codec ?
 
Regards
Ravi kr.
 
 
1 REPLY 1

Ethernet port 1 is reserved for your LAN, port 2 and 3 are used for peripherals such as the Touch 10 and Precision 60 camera. If more than one camera is needed, you should connect a non-managed switch to the SX80 to either port 2 or 3 and connect the cameras to the network switch. The network switch shouldn't supply DHCP, as the SX80's internal DHCP will hand out IP addresses to the connected cameras.
Create
Recognize Your Peers
Content for Community-Ad