cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1045
Views
0
Helpful
5
Replies

Presentation codec frame rate

ehab alabed
Level 1
Level 1

                   what is the frame rate when I using the PiP as presentation output if I have presenation codec

1 Accepted Solution

Accepted Solutions

If using PIP on a CTS 3000 it should be 5FPS.

Using an External monitor your will get 30FPS.

View solution in original post

5 Replies 5

mubakhta
Level 4
Level 4

Hi Ehab,

I believe the frame rate is 30 frames/second when using a Presentation codec. Sharing a presentation without Presentation codec will trasmit at 5 frames/second.

Regards,

Mubashshir Akhtar

Thanks Mubashshir Akhtar

Haydn von Imhof
Level 4
Level 4

Hi Ehad

What system are you using?

For the 500, 1100, 1300 CTS systems, 30FPS is not supported in PIP mode.

So I assume it would be back down to 5FPS

Note The high frame rate codec does not support 30 frames/sec in presentation-in-picture (PIP) mode. An external display is recommended.

The TX series however use a software key and not a presentation codec. So 30FPS in PIP mode might be supported on the TX series.

Thank you,

The system is cts 3000.

if we using the PiP in CTS 3000 with presentation codec the frmae rate is 30fps or its down to 5 fps.

If using PIP on a CTS 3000 it should be 5FPS.

Using an External monitor your will get 30FPS.

Thank you very much

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: