05-07-2008 04:29 AM - edited 03-17-2019 09:21 PM
I have CME running on a Cisco 2801 router and I have installed a 4FXS card. I have an analog phone connected to the port 0/2/0 of the FXS card and the following is configured.
dial-peer voice 201 pots
destination-pattern 4015
port 0/2/0
I am able to initiate calls from this unit however calls to this DN (analog) phone I receive a fast busy.
Also how do I transfer a call from an analog phone in this setup?
05-09-2008 03:06 AM
Hi, I had exactly the same issue ... The attached is a partial configuration that incorporates two POTS lines into a hunt group (800), with CLI services, Unity VM AIM and MWI. The Analog phone is on extension 402. Think you need to look at enabling the service "stcapp" to get your config working
Hope it helps
Regards
Jason
05-09-2008 04:11 PM
Thanks, I tried this config and I am still experincing the same problem. Also I can enable service service stcapp, what is it used for?
05-09-2008 04:37 PM
This is the feature explained:
http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html
After the basic is working, you can configure a fac to access various functions:
http://www.cisco.com/en/US/docs/ios/12_4/12_4x/12_4_6xe/htfeatmd.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: