07-27-2011 10:28 PM - edited 03-17-2019 10:24 PM
Hi, i have MXP6000 with 9.1 software. Cant make it register with SIP. No single packet comes from MXP to server.
Has anyone been able to make it register with SIP server?
Config is quite simple:
xConfiguration Conference SIP URI: "6000@10.96.37.10"
*c xConfiguration SIP Mode: On
*c xConfiguration SIP Server Discovery: Manual
*c xConfiguration SIP Server Address: "10.96.37.10"
*c xConfiguration SIP Server Type: Auto
*c xConfiguration SIP Authentication UserName: "6000"
*c xConfiguration SIP Transport Default: UDP
*c xConfiguration SIP TLS Verify: Off
*c xConfiguration SIP ICE Mode: Off
*c xConfiguration SIP MNS Mode: Off
*c xConfiguration SIP ForceTurn Mode: Off
*c xConfiguration SIP DefaultCandidate Type: Host
*c xConfiguration SIP Legacy Mask: ""
*c xConfiguration SIP ReplyTo URI: ""
07-28-2011 08:11 PM
you trying to register it to what type of servers ?
also the above SIP using UDP is the server using UDP, TCP, TLS ?
07-28-2011 09:03 PM
Does it matter? NO REGISTER packets arrived to server, i was sniffing traffic.
Problem solved just after i entered valid DNS server address in IP parameters. Why would it need DNS if i'm using direct IP addresses...
Anyways, my SIP server (Asterisk) does not support duo-video and because there is two video streams in SDP message, it choses wrong RTP port and streams other's side video to presentation channel.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide