cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
5003
Views
0
Helpful
2
Replies
Highlighted
Beginner

Restore MX200 to factory default

Hello engineers,

How do I restore the MX200 to factory default by a hardware way? How do I restore with SSH commad?

Regards

Dario

2 REPLIES 2
Highlighted
Cisco Employee

Highlighted
Cisco Employee

Hi,

From SSH use commnad :

xcommand SystemUnit FactoryReset Confirm: yes

You can also reset it by using reset button,

  • TC 4.2.x and TC 5.0.x
    1. Remove the cover on the back of the MX200/MX300
    2. Turn off power and wait  5 seconds
    3. Turn on power, and wait 1 second before pusing reset & hold  until the white LED (over screen to the left of camera) starts to blink  (15-20 seconds)
    4. Push the reset button 2 times as soon as it starts to blink
  • TC 5.1 and later
    1. Remove the cover on the back of the MX200/MX300
    2. Either when powered off or when system is up: Press and hold  for approximately 10 seconds - the screen will go black. The system will  factory reset and come up with a confirmation dialog stating that the  factory reset was succesful.

HTH

kind regards,

Dharmmesh

Content for Community-Ad