11-11-2019 05:54 PM
Hi,
Any issue in using 4 x Cisco Ceiling Mics passing through a DSP first, mixing the 4 signals into two audio channels, then output from the DSP into Mic-1 and Mic-2 of the Cisco room Kit plus codec;
Would this affect any of the functionality of the microphones? In particular, mute functionality? as the mics cabling is “4-pin” with pin#4 sending mute commands to the mics.
Appreciate your inputs on this.
Regards
Solved! Go to Solution.
11-12-2019 08:38 AM
when you press the mute button on the Touch 10, it isn't sending a mute command to the mic (s), it's muting the port on the codec. the Pin 4 is only relevant for table mics that have the mute button on them, it has no play in ceiling mics.
So - will what you suggest work? I would imagine so. that said, you should consider the RK Pro instead of plus - sure it costs a bit more but now you don't have to worry about buying/configuring/tuning a DSP, just plug the mics directly into the codec.
11-12-2019 08:38 AM
when you press the mute button on the Touch 10, it isn't sending a mute command to the mic (s), it's muting the port on the codec. the Pin 4 is only relevant for table mics that have the mute button on them, it has no play in ceiling mics.
So - will what you suggest work? I would imagine so. that said, you should consider the RK Pro instead of plus - sure it costs a bit more but now you don't have to worry about buying/configuring/tuning a DSP, just plug the mics directly into the codec.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: