05-28-2012 06:52 PM - edited 03-17-2019 11:13 PM
1)I am configuring the Route Pattern for my Remote Site
2)I have HO where CCM is located and remote site where via MPLS link i am trying to register my phones,phones are registered CUG calling is happening between HO and Remote site but not able to make LOCAL,STD,ISD calls from Remote site
3)My Remote site numb is 4502XXX and i have configured router pattern for STD,ISD and Local but it does not work when i apply CSS and Partition to my phones
4)Also Remote iste uses AREA CODE for dialing to other cities 0124
Thanks in Advance for Help
05-28-2012 07:19 PM
Hi
In the gateway Enable debug isdn q931 and try to call the STD ISD number. Send me debug output.
Regards
Ronak Patel
Rate helpful posts.
05-28-2012 07:36 PM
05-28-2012 07:58 PM
Hi
Your call is blocked because you have dialed number which starts from 9 "9892895616" and your route pattern starts with 0 so it will never match.
regards
Ronak Patel
Please rate helpful posts by clicking stars below the answer.
05-28-2012 08:34 PM
But i have configured to remove the PRE DOT number i dial 0 first and den the number
05-28-2012 10:28 PM
Hi Ronak,
In ISDN debug i dont get anything even if i dial
05-28-2012 11:18 PM
Hi
Is your GW regestered to CUCM properly.
Regards
Ronak Patel
05-28-2012 11:29 PM
HI
Also your route pattern is 0.[1-8] and you are dialing 09. So how would it match? make it [1-9]
regards
Ronak Patel
Please rate helpful posts by clicking stars below the answer.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: