08-14-2012 10:08 AM - edited 03-17-2019 11:36 PM
Dear All;
I have H323 Voice Gateway with a number of FXO ports, this gateway is defined in CUCM 8.5,
every thing is working fine, I can use the fxo port to send offline calls and recieve incomming call on fxo port, but when i recieve the call on the IP phone it does not displayed the Caller ID, instead of that it displaed "..Unknown Number",
My question is : How to display the caller ID for the calls comming on the FXO port, and that calls are forwarded to cucm.
Thanks in Advance,
Rashed Wardi.
08-14-2012 12:17 PM
Check if it's enabled under FXO voice port
caller-id enable
Make sure that your Telco have it enabled on their end.
Thanks,
Zouheir
Sent from Cisco Technical Support iPad App
09-04-2012 12:04 PM
it is enabled but still not work, and i test the pstn line, i can recieve the caller id by using normal analog phone.
please advise if there any configuration needed
09-05-2012 03:22 AM
Configure caller-id enable under voice-port.
Then if still trouble search forum for common issues and workarounds.
04-09-2013 02:54 AM
Hi Rashed
i have same exact issue
did you solve it ?
04-14-2013 04:35 AM
yes the proplem is resolved with me, i will give you the configuration as soon as possible.
11-27-2013 03:50 AM
Hello I have the same issue. Could I please ask how you resolved this?
Thanks
Nic
02-07-2014 11:35 PM
Hi Rashed
i have the same issue... can you please share how did you solve the issue.
Thank You
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: