cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1666
Views
0
Helpful
7
Replies
Highlighted
Beginner

Sending Caller ID to CUCM

Dear All;

I have H323 Voice Gateway with a number of FXO ports, this gateway is defined in CUCM 8.5,

every thing is working fine, I can use the fxo port to send offline calls and recieve incomming call on fxo port, but when i recieve the call on the IP phone it does not displayed the Caller ID, instead of that it displaed "..Unknown Number",

My question is : How to display the caller ID for the calls comming on the FXO port, and that calls are forwarded to cucm.

Thanks in Advance,

Rashed Wardi.

7 REPLIES 7
Highlighted
Cisco Employee

Check if it's enabled under FXO voice port

caller-id enable

Make sure that your Telco have it enabled on their end.

Thanks,

Zouheir

Sent from Cisco Technical Support iPad App

Highlighted

it is enabled but still not work, and i test the pstn line, i can recieve the caller id by using normal analog phone.

please advise if there any configuration needed

Highlighted

Configure caller-id enable under voice-port.

Then if still trouble search forum for common issues and workarounds.

Highlighted

Hi Rashed

i have same exact issue

did you solve it ?

Highlighted

yes the proplem is resolved with me, i will give you the configuration as soon as possible.

Highlighted

Hello I have the same issue. Could I please ask how you resolved this?

Thanks

Nic

Highlighted

Hi Rashed

i  have the same issue... can you please share how did you solve the issue.

Thank You