cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
211
Views
0
Helpful
1
Replies
Highlighted
Beginner

Settings for Cisco P60 Camera

I am working on an AV install using some existing Cisco P60 cameras that will not connect directly to a codec.

I want to set the video output to 1080/30 rather than the current 1080/60

I know the older cameras has some switch settings that allowed me to do that, can I do that with the P60s and a software command?

Thanks

1 REPLY 1
Highlighted
Cisco Employee

What codec are you trying to connect to that won't accept 1080/60? That has been a supported input since C series, are you trying to connect it to something other than a Cisco endpoint? 

 

If you think the camera has failed I would try connecting it directly to any HDMI monitor to see if it works. I'll see if there's any guide on directly connecting to the camera via IP. 

Content for Community-Ad