cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1025
Views
0
Helpful
1
Replies
martyveerdonk
Beginner

setup CME to CUBE

Hello,

i want to setup a CME which has a SIP trunk to a CUBE.

Both are running in my test lab.

Can anyone help me with the configuration of both? Do i need to setup a User Agent on both or only on the CME?

Thanks in advance.

regards, Marty

1 REPLY 1
Felipe Garrido
Cisco Employee

You'll just need to configure dial-peers to point calls between the two devices. There is no need to register anything.

On the CME it should look something like this,

Inbound dial-peer:

dial-peer voice 1 voip

incoming called-number

session protocol sipv2

dtmf-relay rtp-nte

codec g711ulaw

no vad

Outbound dial-peer:

dial-peer voice 2 voip

destination-pattern 9T

session protocol sipv2

session target ipv4:

dtmf-relay rtp-nte

codec g711ulaw

no vad

You'll need to configure a translation rule to strip off the 9 either on the CME or CUBE.

Similar dial-peers will need to be configured on the CUBE.

-Felipe

Create
Recognize Your Peers
Content for Community-Ad