Hi,
i have a cisco router 2921 with voice licence and i want to configure SIP trunk with my provider.
the configuration is next:
voice service voip
no ip address trusted authenticate
address-hiding
dtmf-interworking rtp-nte
allow-connections sip to sip
no supplementary-service sip moved-temporarily
no supplementary-service sip refer
sip
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g711alaw
!
dial-peer voice 130 voip
numbering-type unknown
preference 2
destination-pattern .T
media forking
rtp payload-type comfort-noise 13
session protocol sipv2
session target ipv4:192.168.1.2:5060
session transport udp
voice-class codec 1
voice-class sip early-offer forced
dtmf-relay rtp-nte sip-notify sip-kpml
ip qos dscp cs5 media
ip qos dscp cs4 signaling
!
dial-peer voice 160 voip
description +++To Asterisk+++
numbering-type unknown
preference 1
destination-pattern 4951T
rtp payload-type comfort-noise 13
session protocol sipv2
session target ipv4:172.16.1.1:5060
session transport udp
voice-class codec 1
dtmf-relay rtp-nte sip-notify sip-kpml
!
i can do calls via My provider but when i try to call internall numbers, i fail. i have translation-profile configured correctly, i guess that is not hte problem.
what i discovered is that i send SIP signaling to 192.168.1.2:5060, and ISP accests and calls work, but when the Provider initiate SIP session, he initiate with source Port 5062, and my router does not ceate incomming leg:
*May 5 16:06:58.788: //1393/3331D6519C88/SIP/Error/act_recd_invite_send_msg_failure:
Send Error to 192.168.1.2:5062 for transport UDP
*May 5 16:06:58.788: //-1/xxxxxxxxxxxx/SIP/Error/sipSPIGetContentQSIG:
No Inbound Container Created !!!
can somebody help me with this issue? can i change the dialpeer to receive from one source port but send to 5060?