spark kit mini

[michael.kahler]

Does anyone know if I can install a spark kit min below a display? Will the camera orientate when hung upside down? I've spent 3 hours trying to get cisco to answer the question but it seems to be top secret and I don't have security clearance.  

[PJMack]

Page 19 of the installation guide shows you how to flip the setup if you want below the screen. I would bet that the camera orientation will flip if Cisco is giving you instructions on how to mount it that way. 

https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/room-kit/installation-guide/cisco-webex-room-kit-mini-installation-guide-multilingual.pdf

[michael.kahler]

Thank you for the reply, I was assuming that but the black and white answer is a well, guarded secret. Thanks again..

[michael.kahler]

I’ve installed the mini and it in fact, does invert the image so that the camera can be mounted top or bottom.

[PJMack]

Very good! Now Cisco's secret is out.......:)

[Ashish Patel]

The install guide shows on p11 and p19 you can mount it below see below. This all depends however on how the room looks and how the other end will see the table/room at the far end.
Also consider modesty/privacy panel if you happen to capture a view under the table. For a huddle room setup this may not apply as it should be small room anyways.
https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/room-kit/installation-guide/cisco-webex-room-kit-mini-installation-guide-multilingual.pdf
Rgs
ashish