Hope you fine gentlemen can help me out here... I am trying to get an SX10 which is registred with CUCM to call to webEx CMR using the IP address as one of our devices does not support SIP. But i keep getting: SIP/2.0 400 Bad Request - 'Malformed/Missing URL'
Call Flow is: SX10 >>>> cucm >>> Expressway
But calls never make it to expressway, drop by CUCM. Here is what i get from the SDL file
"I am trying to get an SX10 which is registred with CUCM to call to webEx CMR using the IP address as one of our devices does not support SIP. "
If you have an SX10 registered to CUCM, it's registered as a SIP client, and if you have Expressway setup for internet/B2B calling, that should be a URI call to Webex, typically the nine digit meeting number @yourcompany.webex.com
For IP address dialing to work from CUCM registered endpoints, you usually will use some kind of trigger - at my company we dial the address with a suffix of "@ip" - so for example 22.214.171.124@ip, then in CUCM there's a route pattern to send it to Expressway and it works.
Here is the deal, internal i have no issue to dial to WebEx. And yes, we dial the meeting ID follow by the IP address as our UC platfor is fully SIP supported. However, our Parent Computer which is in Asia, their Vid Conference devices do not support SIP, they support H323. I do CUCM can dial H323, I have added a SIP route pattern with Webex external IP address which is also add in the meeting invite,still CUCM rejects the dial with : SIP/2.0 400 Bad Request - 'Malformed/Missing URL'
Hi all, I am planning to purchase a VG310, RJ21 cable and the patch panel, is there anyone who can confirm the following specifics. Cat5 25 Pair or is this Cat3 25 Pair:Do i need FT4 or FT6:Male or Female Connector on the Amphenol end: Than...
This VG is connected with CUCM via MGCP. On the CM, GW has been registered.I don't think I can get the inbound correctly. Any suggestion with below configure: interface BRI0/1/0no ip addressisdn switch-type nttisdn point-to-point-setupisdn incom...
Hi, My name is JanetMy portal ID is https://nwswdvcas-taw.my.webex.com/meet/janet.dvcasI do want you please to delete both my accounts with Webex (free and Paid)So my organisation can join me on another Webex Account as another Host. I did foll...
Our beginner online classes are designed to help IT Admins plan, deploy, and manage their Webex Control Hub environment. Start off by learning what critical elements are needed to deploy Control Hub or move into Webex features that can be used to better ...