cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
581
Views
0
Helpful
1
Replies

SX20 remote limit range if connect LAN

Joejohn
Level 1
Level 1

Hallo all,

I have issue, suddenly SX20 device only responding to remote control (TRC V) from specific angle to the device (around 30-45 degree) and limited range (less than 1 meter) when it connected to LAN, but if the codec didn’t connect to LAN, remote looks fine and normal.

We tried to restart SX20 and change the remote control batteries but to no avail.

Is there any miss configuration at the codec?

SX20 using software version TC7.3.18bd50440

attached configuration SX20

Please help, Kindly provide us with solution for this issue

Thanks.

1 Reply 1

Wayne DeNardi
VIP Alumni
VIP Alumni

There isn't anything in the configuration that will affect this.

Are you testing on-LAN and off-LAN with the codec in the exact same location and position?

Is there a Cisco Camera connected?  Is the Camera Connected in both your testing scenarios? (the IR receiver in the camera will be used if connected correctly instead of the IR receiver located in the power button on the SX20).

Wayne
--
Please remember to mark helpful responses and to set your question as answered if appropriate.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: