I have an outstation using an SX20 with an ISDN link. It goes through an external crypto device. When calling direct for on ISDN kit to another there is no issue and the picture and video are good. When I dial from the MCU/ISDN GW on 128k it connects for a few seconds then ends the call. When dialling out on 64k the call connects but I receive no video only audio.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...