cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
229
Views
0
Helpful
2
Replies
Highlighted
Beginner

SX20 with multiple SIP Proxies

Hi all,

Does anyone has experience in configuring a TelePresence endpoint (like SX20) with multiple SIP proxies?

I assume it is not possible to make the SX20 registered into different SIP servers, but it is possible to configure up to 4 Proxy Addresses, to make outbound calls possible through different SIP proxies. (For example SX20 is registered in CUCM, but also can make calls through a different SIP server/proxy...)

What are the requirements against those proxies? What would be the routing policy between the configured proxies (top-down)?

Thanks,

Tibor

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Advisor

That is not the way it works,

That is not the way it works, because the SX20;s dont have a local dialplan, they have no way of prioritising what proxy to use for what call, that call routing intelligence lies totally with cucm,  your proxies should be a reflection of your CUCM-group in CUCM

Please rate if useful

Please remember to rate useful posts, by clicking on the stars below.

View solution in original post

2 REPLIES 2
Highlighted
VIP Advisor

That is not the way it works,

That is not the way it works, because the SX20;s dont have a local dialplan, they have no way of prioritising what proxy to use for what call, that call routing intelligence lies totally with cucm,  your proxies should be a reflection of your CUCM-group in CUCM

Please rate if useful

Please remember to rate useful posts, by clicking on the stars below.

View solution in original post

Highlighted
Beginner

Hi Dennis,

Hi Dennis,

thanks for clarifying this.

Tibor

CreatePlease to create content