Setting up a dial plan on port A (internal) to allow a short code to be dialled to push off to an MCU hosted on a Private WAN accessed via port A. Calls coming in from CUCM 6.1.2 from IP phone with VTA. I have configured a test dial plan as follows:
Condition - Called number matches 1
Action - Call this number <ip address of remote MCU> H.323 without gatekeeper.
I have tested the dial plan but the call fails to connect. Have run a connection test from the ip gw and the ping/traceroute complete no issues.
If I dial the IP GW and enter the IP Address directly using the keypad then the call connects to the remote MCU without a problem.
Any suggestions on what is different between a call initiated by a dial plan as opposed to entering the ip address manually? And how to resolve the issue?
Many thanks for the response. Other options seem to work for the dialing number but i have them going out the external interface. Aware of the order of the number patterns but thanks for mentioning it.
Re the IVR on the MCU issue i have is it is not my MCU. hence trying to create a short dial to it. might just have to setup a new address in the end points address books.
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...
CUCM can backup the manually or have sehchduler to backup the configuration and historical reports from the server diester recovery systemStep 1. Navigate to CUCM > Disaster Recovery System > Backup > Manual Backup as shown in the...