I have teleprecense MX200 ,and for user interface there is only touch screen and no control panel.In datasheet i can`t find out something about control panel.Can i use control panel from C60 to control MX200 ? is there power/lan adapter for touch screen which gives we to control my MX200 thought lan ?
Is this adapter comes with MX200 boundle or i my to order it ?
There are a few different models of touch panel (and different sizes available) - not all are the same, and don't necessarily work on all devices.
Here's the list from the Cisco TelePresence Touch Devices Datasheet
Cisco TelePresence Touch 8-inch for EX Series
Cisco TelePresence Touch 8-inch for Integrator C Series, Profile Series, Quick Set Series
Cisco TelePresence Touch 8-inch for MX Series
Cisco TelePresence Touch 10-inch for MX Series
Cisco TelePresence Touch 12-inch for CTS 500, 1100 and 1300 endpoints
Cisco TelePresence Touch 12-inch for TX endpoints
Note: the C60's panel has a different part number to the MX200's.
Please remember to rate responses and to mark your question as answered if appropriate.
thanks for reply.
Is there power adapter for touch pannel which gives opportunity to control MX200 thought LAN ?
I know that C series have adapter which gives opportunity to control C series teleprecense throught LAN ?
I only know the MX300, there you connect the touchpanel directly to the codec/display. No additional power adapter or LAN port necessary.
It seems like the MX200 is identical to the MX300. Look to the install guide on page 5. There you can see the Touchpanel Port.
- Please rate helpful posts -
I used touch screen to control C60 throught lan.It`s very comfortable to control teleprecense throught Lan.But in Mx200 Datasheet i couldn`t find to control him throught Lan or remote control,only touch screen which connected directry to MX200