cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

2551
Views
0
Helpful
8
Replies
Highlighted
Beginner

TMS connection

We supervise codec's using TMS.

TMS can not connect the codec after network of codec changed .

We are checking network..

What is port that TMS use when TMS give phonebook to Codec and connect to codec?

then dose TMS use SNMP port only(161,162)? or other port?

i saw information of manual

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tms/install_guide/Cisco_TMS_install_guide_13-2.pdf

Everyone's tags (2)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Engager

Re: TMS connection

I would open for Tandberg/Cisco endpoints:

form TMS to the endpoint:

TCP: 20,21,22,23,57,80,443

UDP: 161

from the endpoint to the TMS

TCP: 80, 443

UDP: 162

The corporate phonebook for MXP and TC systems will use port http=tcp/80 or https=tcp/443

depending on what you have configured or whats aailable

Please remember to rate helpful responses and identify

View solution in original post

Beginner

TMS connection

Martin,

Where can i find settings for TCP & UDP Ports in TMS ??

Regards

View solution in original post

8 REPLIES 8
Engager

Re: TMS connection

I would open for Tandberg/Cisco endpoints:

form TMS to the endpoint:

TCP: 20,21,22,23,57,80,443

UDP: 161

from the endpoint to the TMS

TCP: 80, 443

UDP: 162

The corporate phonebook for MXP and TC systems will use port http=tcp/80 or https=tcp/443

depending on what you have configured or whats aailable

Please remember to rate helpful responses and identify

View solution in original post

Re: TMS connection

For Aethra and Polycom endpoints are the same ports listed above?

Thanks

Cisco Employee

Re: TMS connection

Yes, TMS provides the phonebook via http/s 80/443 as Martin is saying. So assuming the endpoints support phonebooks from tms ( dont know about aethra, but certain polycoms does) they have to use the same ports to get the phonebook.

Sent from Cisco Technical Support iPhone App

Beginner

Re: TMS connection

Hello,

For polycom, I have to open FTP (21)  for phonebook (polycom vsx)

Beginner

TMS connection

Martin,

Where can i find settings for TCP & UDP Ports in TMS ??

Regards

View solution in original post

Beginner

TMS connection

martin

thanks for your answer

regard

Beginner

TMS connection

Our issue is solved by adjusting MTU size of TMS.(1500->1460)

TMS OS: Windows 2003

is it no problem?

Beginner

TMS connection

Hi,

For polycom below ports are required for phonebook:

TCP Port 3361 – Required for Global Address Books - For 1st and 2nd Gen

TCP Port 3601 – Outbound from device Required for Global Address Books - For VSX, HDX, IPower and ViaVideo I & II Series.

Regards

Sumeet Rakesh

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here