cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1770
Views
20
Helpful
4
Replies

Touch 10 and C-Series End Points

Hi,

I have seen that the Touch 10's are not supported by the C-Series End Points.  Is this a software issue or a older hardware issue?  I am using TC7.3 which is the same version as SX20's that support the touch 10.

I have a C40 that has a damaged Touch 8 and I would like to replace it with a Touch 10.  I believe that the Touch 8's are no longer for sale.

 

Can anyone help?  Does the Touch 10 work with a C40 but its not supported? Or does it not work at all?

 

Thanks,

 

Rob

Everyone's tags (6)
4 REPLIES 4

Touch 10 is only supported on

Touch 10 is only supported on the newer endpoints (currently the SX10/20/80, MX200/300 G2, and MX700/800), this is because the UI of the touch goes hand and hand with the updated UI of those endpoints.  It's not possible to pair a Touch 10 with any of the older C or MX Series codecs as the UI of each are different, and I'm sure the support for the Touch 10 isn't in the codec's software.

Currently the Touch 8 is not EOS.

VIP Advisor

As Patrick has said (+5), the

As Patrick has said (+5), the Touch 10 is not supported on the older endpoints.

This is written in the "Cisco TelePresence Touch 10 hardware dependencies" section of the TC7 release notes (Page 96) - where it says: "The Touch 10 panel is supported only by the following systems: SX10, SX20, SX80, MX700, MX800, MX200 G2 and MX300 G2."

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Beginner

Re: As Patrick has said (+5), the

Hi Experts,
I have a doubt, the Touch CTS-CTRL-DV10 already came out EOS and has no replacement, we drive an MX300 and the touch is damaged
Now the most up-to-date telepresence devices bring a Touch with SKU: CS-TOUCH10 =

My question is, will the new touch CS-TOUCH10 = be compatible with the MX series?

I will appreciate your support.

regards
Charles.

Highlighted
VIP Advisor

Re: As Patrick has said (+5), the


@carlos.perez1 wrote:

My question is, will the new touch CS-TOUCH10 = be compatible with the MX series?


Yes, the new model Touch10 will work with any of the systems that previously supported a Touch10 - you just need to make sure you are running an up to date software release on the endpoint as the newer Touch10s need a minimum of CE8.3.3 or CE9.1.1.

The Touch10 will not work on one of the older devices (such as the C series mentioned by the original poster) that only support a Touch8.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards