07-23-2012 11:15 AM - edited 03-17-2019 11:30 PM
WIth the latest software upgrade to TC 5.1.3 I have a locations where their network is retricted to one MAC address per port. Since the software upgrade the EX60/90 is broadcasting two MAC addresses per port; one for the codec and one for the touch panel. Is there a software change to prevent the touch panel MAC address from being broadcasted?
Solved! Go to Solution.
07-23-2012 11:24 AM
Hello,
I think you are running into following ddts :
Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?
07-23-2012 11:24 AM
Hello,
I think you are running into following ddts :
Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?
07-23-2012 11:39 AM
Thanks for your prompt response.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: