cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
608
Views
5
Helpful
1
Replies
Highlighted
Participant

TX9000 Remote Call Launch

Is anyone familiar with remotely accessing a TX9000 to launch a call for troubleshooting?  Procedures, issues, limitations?

1 REPLY 1
Highlighted
Cisco Employee

Re: TX9000 Remote Call Launch

TX series and all CTS units have the ability to launch calls from the SSH admin command line, as well as view call status.  Simply log into the admin CLI and enter "call start " to start the call.  "Show call status" will allow you to see negotiated bandwidth, resolution and other relevant call information. 

For all commands and their functions (below is for TX 6.0 software, the commands are simillar throughout earlier versions):

http://www.cisco.com/en/US/partner/docs/telepresence/tx_sw/6_0/command_ref/tx_sw_cli_cmd_call.html

Thanks -

Tina