cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
256
Views
0
Helpful
1
Replies
Beginner

Unsecured Active Control for Jabber for Windows through MRA via Expressway v12.5.4

We recently upgraded our Expressway C and E clusters from 12.5 to 12.5.5.  When reading the release notes, one of the new features we received (in 12.5.4) is the MRA: Support for Encrypted iX (for Active Control)

 

https://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/release_note/Cisco-Expressway-Release-Note-X12-5-5.pdf

 

"MRA: Support for Encrypted iX (for ActiveControl)

ActiveControl over MRA is already supported with encrypted phone profiles. This feature will allow MRA video endpoints and Jabber clients with non-secure phone security profiles to negotiate ActiveControl so that users can see roster lists, layouts, and other iX-dependent ActiveControl features in video meetings. There are no configuration or interface changes for this feature. However, you may need to rediscover your Cisco Unified Communications Manager servers after you upgrade the Expressway."

 

We are on CUCM v11.5(1)SU6.  WE don’t use encrypted phone profiles so we don’t have ActiveControl in our non-MRA environment currently. After the Expressway upgrade to 12.5.5, I rediscovered the Call Manager cluster with Expressway and tested over MRA Jabber for Windows (v12.6.2), however I am not seeing contact lists or any Active Control features.  I’ve also made sure the “Allow iX Application Media” and “Allow Presentation Sharing using BFCP” options are enabled on the SIP profile for the J4W CSF config. Is it possible this is only a feature available in CUCM 11.5 or only 12.5?

 

 

 

 

 

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Re: Unsecured Active Control for Jabber for Windows through MRA via Expressway v12.5.4

Functionality not available until CUCM 12.5

View solution in original post

1 REPLY 1
Highlighted
Beginner

Re: Unsecured Active Control for Jabber for Windows through MRA via Expressway v12.5.4

Functionality not available until CUCM 12.5

View solution in original post

CreatePlease to create content