I have VCS Control ,VCS Expressway and CUCM 8.0 in the lab.
Please let me know how to integrate CUCM 8.0 with VCS Control and Expressway.
Any Document or supporting URL would be helpful.
Thanks in advance.
document as bellow
CUCM integration with VCS
VCS and VCS expressway integration
if helpful Rate
I am just trying the integration with not success, I am getting this issues:
Do you have any idea? I will apprecited.
I see below in the search:
which says "Reason: Service Unavailable"...so my question is whether the trunk to CUCM is showing active on VCS?
it would appear you're trying to do a LOCATE of SIP alias that is not found in the DEFAULT ZONE and you have not specified a domain name in the alias.
Failed to start locate: Out of resource
will come when you try to locate a E.164 number or any alias without a domain and you select the protocol as SIP under locate.
since the trunk is showing active i think its good if you capture the netlog 2 or diagnostic log when you try to create the issue. and check whether the INVITE is sent to CUCM or not.
Also i think you would like to open the case with Cisco TAC for this issue.