cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
502
Views
0
Helpful
1
Replies

VCS image fail

Nick Boylan
Level 1
Level 1

We have a VCS that will not load the firmware. I have tried to load the 2nd image but that fails too.

I would like to re image the VCS completely but I'm unsure of the commands. I have a TFTP server that I can use but ideally I'm after a little guidance and advice.

I have performed a firmware reload on endpoints before but I'm a little unsure about the VCS.

Thank you

1 Reply 1

ahmashar
Level 4
Level 4

can you login via ssh to VCS? VCS unlike CUCM doesn't use TFTP for imaging. if you can SSH and then you can do a factory reset. here is how:

login as root, then try to do factory reset:

-    Type in at prompt:   factory-reset

then you can upgrade or install to your desired version.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: