I have a neighbourhood zone set up betwwen 2 VCS and it is registered. 1 location has 1 MCU and the other has 2. The location with 1 mcu can only make a call to one of the MCUs at the other location and not the other. Also i cant make a call from either MCU on the side with 2 to the single MCU.
Any ideas? have i configured it wrong on the VCS or MCU
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...