cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
485
Views
0
Helpful
1
Replies
wayne curley
Beginner

VCS search rule

I am trying to dial out from our MCU to an endpoint with an IP address

i.e. 44001@xxx.xxx.xxx.xxx.

I have "44" defined as an H323 prefix.

When I try to out dial this number from the MCU it never goes to the traversal zone it keeps ending up in the DefaultZone.

I think this is becuase I have the "44" defined as an H323 prefix.

What search rule can I put in to make sure it goes to the traveral zone and out of my network

thanks

1 REPLY 1
Tomonori Taniguchi
Cisco Employee

Can you post your current search rules configuration to understand current search rules and priority configuration?

Ideally you can add additional search rule for 44001@xxx.xxx.xxx.xxx with higher priority than local zone search (for prefix 44 to MCU).

Content for Community-Ad

Spotlight Awards 2021