07-23-2014 01:47 PM - edited 03-18-2019 03:13 AM
Hello Community,
can you please explain me, how I put a VCSESTRTPACK to Internet? Just put the public IP-Address to the Interface configuration? I just have one public IP, so I have to NAT? Or is it possible to make it work. I want to register devices from outside over the Internet. Some endpoints are behind NAT.
How is the routing configuration and the network deployment?
I will put the VCSESTARTPACK for register server from external endpoints over the internet.
And for internal service use a MCU and TMS. So I nedd communication from intern and extern to my VCSESTARTPACK. Is it possible to connect a internal VCSC to it to increase registrations?
Thank you
Solved! Go to Solution.
07-23-2014 03:16 PM
Duplicate posts.
Go here: https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse
07-23-2014 03:16 PM
Duplicate posts.
Go here: https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse
07-24-2014 05:46 AM
Before we want to update the STARTPACK to a VCSE, we want to put it on the public IP. How does it works? Just configure the Interface with a static public IP?
So we want to build up the system without DUALNIC first. I can put it on the DMZ or outside. If I configure a public IP on the VCS I don´t need the DUAL feature, right?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: