VCS/Tandberg Patches x6.0

[S.Srivas1]

Hello Forum,

I have a customer using VCS x.6 with hardware version 1.0.

No support contract in place now.

Customer want to update  the security patches for VCS Control and VCS Express.

There is no immediate intention to upgrade software.

However, I need to advice if the Tandberg Hardware version 1.o can be upgraded to latest software version, and the requirements of support contract.

Thanks with Appreciation.

[Justin Ferello · Accepted solution]

Serial numbers that start with 52A1xxxx-52A4xxxx can be upgraded to x8.8.3

Serial numbers that start with 52A0xxxx can only be upgraded to x8.7.3

The above may be moot in your customer's case since the last date to attach a new contract to a Gen1 VCS was in 2015.

See attachment for EoL

[S.Srivas1 · Accepted solution]

VCS Control is 52A3

I'm still checking VCSe.

Will update

[S.Srivas1]

Thank you Justin for the prompt answers.

the VCSe is running

Software version: X7.2.4.

Portions of this software are licensed under 3rd party licenses. See the Copyrights documentation available on the support section of the web site for details.

I'll look into upgrading both.