05-25-2011 03:38 PM - edited 03-17-2019 10:19 PM
Hello everyone
Such configurations are available below.
phone - PBX - router - WAN - router - PBX - phone
In this case, what should I use which module?
VIC2-2BRI-NT/TE ? VIC-2BRI-ST/TE ?
I am aware of 「VIC2-2BRI-NT/TE」 is used.
05-25-2011 03:43 PM
sorry.
Correct the contents. PBX module is used to connect
VIC2-2BRI-NT/TE ? VIC-2BRI-ST/TE ?
I am aware of 「VIC2-2BRI-NT/TE」 is used.
05-26-2011 10:09 AM
It depends on the router model. Check:
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml
05-26-2011 07:44 PM
Router, "2901" is used.
"2901"is supported by both modules.
05-27-2011 03:27 AM
ISR and ISR G2 only supports VIC2 modules.
Please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: