cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2976
Views
0
Helpful
3
Replies

VIC2-4FXO not working on Cisco 2811

hrnaqvi12
Level 1
Level 1

Hi All,

I have installed VIC2-4FXO card on Cisco 2811 at slot 3.

Following is the results of output commands

command "show inventory" reveals

NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 3", DESCR: "2nd generation four port FXO voice interface daughtercard"

PID: VIC2-4FXO         , VID: V01 , SN: FOC103031YV

command "show version" reveals

Cisco 2811 (revision 53.51) with 249856K/12288K bytes of memory.

Processor board ID FHK1237F2GX

2 FastEthernet interfaces

1 Virtual Private Network (VPN) Module

4 Voice FXO interfaces

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

but when I give the command "show voice port summary" nothing is displayed.

I am using the following IOS, "c2800nm-adventerprisek9-mz.124-22.T4.bin".

This is now becoming a show stopper for me. Kindly help me out.

Regards,

Hasnain Naqvi

1 Accepted Solution

Accepted Solutions

Aaron Harrison
VIP Alumni
VIP Alumni

Hi


What else does 'show inventory' show?

Do you have PVDMs? If not, no voice ports will activate. You will also likely see a message when the router is booting relating to this problem.

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

View solution in original post

3 Replies 3

Aaron Harrison
VIP Alumni
VIP Alumni

Hi


What else does 'show inventory' show?

Do you have PVDMs? If not, no voice ports will activate. You will also likely see a message when the router is booting relating to this problem.

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Hi Aaron,

Thanks for your post.

I think I am missing PVDMs, but anyhow If PVDMs are missing, why port is not being activated?

"show inventory" complete output is this

NAME: "2811 chassis", DESCR: "2811 chassis"

PID: CISCO2811         , VID: V05 , SN: XXXXXXXXX

NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 3", DESCR: "2nd generation four port FXO voice interface daughtercard"

PID: VIC2-4FXO         , VID: V01 , SN: FOC103031YV

Thanks after installation PVDM it worked.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: