05-20-2010 09:06 AM - edited 03-17-2019 10:00 PM
Guys,
I am trying to make video calls via the Cisco 9971 to another 9971 on the same cluster but am not able to make a video call at all.
Any ideas on how I would set this up or point me in the right direction on how setting this up
Im running CCM Version System version: 7.1.5.10000-12
Cisco 9971 Firmware version: sip9971.9-0-2
Under Phone configuration > Product Specific Configuration Layout > Cisco Camera has been enabled and so has video capabilities.
But am not able to make a video call side by side from one to another and vice versa.
Kunal Patel
06-26-2010 07:00 AM
Hi.. I'm using CUCMBE 7.1.3
My CUCMBE upgrade to Engineering Special 7.1(3.33030.1),
Cisco 9971 Firmware version: 9971.9-0-3
and Video Call between 9971 is running well.
Thanks.
If this helps, please rate.
09-29-2014 12:12 PM
Hi Kunal,
Have been able to solve this issue?
I'm facing the same problem.
Best regards,
Alcides
10-14-2014 03:07 AM
My problem was solved the onder video where not enabled. :-)
10-06-2014 08:30 AM
Hi,
did you also set enough bandwidth between the locations and enabled Video in the regions?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: