05-20-2010 09:06 AM - edited 03-17-2019 10:00 PM
Guys,
I am trying to make video calls via the Cisco 9971 to another 9971 on the same cluster but am not able to make a video call at all.
Any ideas on how I would set this up or point me in the right direction on how setting this up
Im running CCM Version System version: 7.1.5.10000-12
Cisco 9971 Firmware version: sip9971.9-0-2
Under Phone configuration > Product Specific Configuration Layout > Cisco Camera has been enabled and so has video capabilities.
But am not able to make a video call side by side from one to another and vice versa.
Kunal Patel
06-26-2010 07:00 AM
Hi.. I'm using CUCMBE 7.1.3
My CUCMBE upgrade to Engineering Special 7.1(3.33030.1),
Cisco 9971 Firmware version: 9971.9-0-3
and Video Call between 9971 is running well.
Thanks.
If this helps, please rate.
09-29-2014 12:12 PM
Hi Kunal,
Have been able to solve this issue?
I'm facing the same problem.
Best regards,
Alcides
10-14-2014 03:07 AM
My problem was solved the onder video where not enabled. :-)
10-06-2014 08:30 AM
Hi,
did you also set enough bandwidth between the locations and enabled Video in the regions?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide