cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
300
Views
5
Helpful
8
Replies
echiyahya
Beginner

Visio Conf Components

Hi,

We are using a Cisco CUCM and IM&Presence system across three sites over MPLS for voice only.  Lately, we are looking for internal Multi-Party Video Conference solution across these three locations using SX20, SX10 and Jabber for mobile. 

Can I make a video conference with current equipments (CUCM and IM&Presence) or t is there are another bridge that I have to add ? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Jaime Valencia
Hall of Fame Cisco Employee

Yes, you can register a vTP to CUCM as a CFB.

HTH

java

if this helps, please rate

View solution in original post

8 REPLIES 8
Jaime Valencia
Hall of Fame Cisco Employee

I suggest you review this, page 18

http://www.cisco.com/c/dam/en/us/td/docs/solutions/PA/midmarket/11x/video11x.pdf

HTH

java

if this helps, please rate

thaks Jaime for the suggestion. but what I want to know is with only 3 sites(one sx10, one sx20 and one jabber for mobile) can i only use CUCM with conference bridge without the TMS and Conductor ?

Jaime Valencia
Hall of Fame Cisco Employee

Yes, you can register a vTP to CUCM as a CFB.

HTH

java

if this helps, please rate

View solution in original post

can you explain more about vTP and CFB ?

Jaime Valencia
Hall of Fame Cisco Employee

You'll register the vTP to CUCM as a CFB, are you familiar with Cisco UC??

http://www.cisco.com/c/en/us/products/collateral/conferencing/telepresence-server/data_sheet_C78-7287571.html?cachemode=refresh

If not, perhaps you should be reaching out to a Cisco partner who can provide advice of what would work best on your particular environment to fulfill your needs for video conferencing.

HTH

java

if this helps, please rate

yes im familiar with CUCM but I have not set before the CFB so i have one last question for clarification
For example:
I'll register an SX20 on CUCM to use it for video conference:
So is what I'm going to Register the SX20 as a device: device / phone / add new / SX20 ...
or
i must go directly to media resources / conference bridge / add new / choose the type of CFB /MAC address of the SX20...

Jaime Valencia
Hall of Fame Cisco Employee

The SX20 is an endpoint, not sure under what reasoning, you would try to add it as a CFB

If you're not familiar with media resources, which is something every single deployment I've ever seen uses, you probably want to read the media resources chapter from the system guide, and also the same chapter from the SRND.

HTH

java

if this helps, please rate

OK thanks Jaime for your help :) i'll try to register vTelepresence Server with CUCM as CFB and SX20, SX10, Jabber for mobile  as endpoints.

Content for Community-Ad

Spotlight Awards 2021

This widget could not be displayed.