VMware TelePresence Conductor

[cjoseph23]

Hello All,

I see that the TP Condcutor has VM Option but what i couldn't find it what hardware it is supported on?  Is this supported on UCS only or can we install this on a spec based scenerio.

I tried to find a Doc Wiki or some documentation but couldn't see to find anything.  If anyone has a link could you please share.

Thanks in advance,

CJ                  

[Alok Jaiswal · Accepted solution]

Hi Joseph,

check the below link.

http://www.cisco.com/en/US/docs/telepresence/infrastructure/conductor/config_guide/Cisco_TelePresence_Conductor_Virtual_Machine_Deployment_Guide_XC1-2.pdf

Recommended platform

The recommended hardware on which to run a TelePresence Conductor VM is:

n Cisco UCS C200 – M2, UCS C210 – M2, or UCS B200 – M2 with:

l Processor supporting AESNI feature

l 6GB of RAM per VM

l 132GB disc space per VM (for a 4GB virtual disc 1 and a 128GB virtual disc 2)

l R2XX-LBBU (Raid disk battery backup to enable cache)

l Four hard disks (450GB SAS 15K RPM 3.5in HDD/hot plug/C200 drive sled)

l PCI card Intel Quad port GbE Controller (E1G44ETG1P20)

rgds

Alok

[cjoseph23]

thanks - I was looking through the release notes - didn't think to look here.

Regards,

CJ

[muazam ali]

from where can i download the VM image for TP conductor to install on machine.

[Anthony Thomson]

From

http://software.cisco.com/download/release.html?mdfid=284262814&softwareid=280886992&release=XC2.2.1&relind=AVAILABLE&rellifecycle=&reltype=latest