cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5986
Views
15
Helpful
5
Replies

Voice translation-rule, 15 limit again

k_clausen
Beginner
Beginner

Hi again – Here a new thread for the discussion regarding the voice translation-rule limitation of 15 entry.

I’m aware, that a router is not attended to do the work of a UC manager, but I have the need to translate 20 numbers on the incoming call on the router – like (simple)

voice translation-rule test-more-than-15
rule 1 /^72301090$/ /5710/
rule 2 /^72301091$/ /5720/
rule 3 /^72301092$/ /5730/
rule 4 /^72301093$/ /5731/
rule 5 /^72301094$/ /5760/
rule 6 /^72301095$/ /5763/
rule 7 /^72301096$/ /5780/
rule 8 /^72301097$/ /3115/
rule 9 /^72301098$/ /3116/
rule 10 /^72301099$/ /3290/
rule 11 /^72301290$/ /2272/
rule 12 /^72301291$/ /4550/
rule 13 /^72301292$/ /4560/
rule 14 /^72301293$/ /4490/
rule 15 /^72301294$/ /1045/
rule 16 /^72301295$/ /5740/
rule 17 /^72301296$/ /2455/
rule 18 /^72301297$/ /4140/
rule 19 /^72301298$/ /4160/
rule 20 /^72301299$/ /4390/

Is it possible to split it into e.g. to different dial-peer to overcome the limitation – like:

(some commands left out)

!

voice translation-rule 2
rule 1 /^72301090$/ /5710/
rule 2 /^72301091$/ /5720/
rule 3 /^72301092$/ /5730/
rule 4 /^72301093$/ /5731/
rule 5 /^72301094$/ /5760/
rule 6 /^72301095$/ /5763/
rule 7 /^72301096$/ /5780/
rule 8 /^72301097$/ /3115/
rule 9 /^72301098$/ /3116/
rule 10 /^72301099$/ /3290/
!
voice translation-rule 3
rule 1 /^72301290$/ /2272/
rule 2 /^72301291$/ /4550/
rule 3 /^72301292$/ /4560/
rule 4 /^72301293$/ /4490/
rule 5 /^72301294$/ /1045/
rule 6 /^72301295$/ /5740/
rule 7 /^72301296$/ /2455/
rule 8 /^72301297$/ /4140/
rule 9 /^72301298$/ /4160/
rule 10 /^72301299$/ /4390/
!
!
voice translation-profile 2
translate called 2
!
voice translation-profile test-serie-2
translate called 3
!
!
dial-peer voice 2 voip
translation-profile outgoing 2
destination-pattern .
session protocol sipv2
session target ipv4:172.31.2.34
incoming called-number .
dtmf-relay rtp-nte
codec g711alaw
no vad
!
dial-peer voice 3 voip
translation-profile outgoing test-serie-2
destination-pattern .
session protocol sipv2
session target ipv4:172.31.2.34
incoming called-number .
dtmf-relay rtp-nte
codec g711alaw
no vad

5 REPLIES 5

Adrian Saavedra
Rising star
Rising star

Hi,

You can use num-exp command. You can build a table. You can use more than 15 sentences.

Hope it helps, if it does please rate.

- Adrian.

fengouyang
Beginner
Beginner

Hi clausen,

Try this and see if it works. Hope it helps.

voice translation-rule 2
rule 1 /^72301090$/ /5710/
rule 2 /^72301091$/ /5720/
rule 3 /^72301092$/ /5730/
rule 4 /^72301093$/ /5731/
rule 5 /^72301094$/ /5760/
rule 6 /^72301095$/ /5763/
rule 7 /^72301096$/ /5780/
rule 8 /^72301097$/ /3115/
rule 9 /^72301098$/ /3116/
rule 10 /^72301099$/ /3290/
!
voice translation-rule 3
rule 1 /^72301290$/ /2272/
rule 2 /^72301291$/ /4550/
rule 3 /^72301292$/ /4560/
rule 4 /^72301293$/ /4490/
rule 5 /^72301294$/ /1045/
rule 6 /^72301295$/ /5740/
rule 7 /^72301296$/ /2455/
rule 8 /^72301297$/ /4140/
rule 9 /^72301298$/ /4160/
rule 10 /^72301299$/ /4390/
!
!
voice translation-profile 2
translate called 2
!
voice translation-profile test-serie-2
translate called 3
!
!
dial-peer voice 2 voip
translation-profile outgoing 2
destination-pattern 7230109.

session protocol sipv2
session target ipv4:172.31.2.34
incoming called-number .
dtmf-relay rtp-nte
codec g711alaw
no vad
!
dial-peer voice 3 voip
translation-profile outgoing test-serie-2
destination-pattern 7230129.

session protocol sipv2
session target ipv4:172.31.2.34
incoming called-number .
dtmf-relay rtp-nte
codec g711alaw
no vad

Steven Holl
Cisco Employee
Cisco Employee

This has been expaneded with 15.1(4)M.  You now have 100 rules.  Upgrade and have at it!

Router(config)#voice translation-rule 1
Router(cfg-translation-rule)#rule ?
  <1-100>  Translation rule tag

Hi, Steven,

i have 100 limit in translation rule, but i have 110 numbers, which is needed to be translated. How i can aproach this task? 

Try and see if you can create some rules in such a way that can cater to multiple digit manipulations and if that is not possible, simply go ahead with creating more translation-rule and then create the additional remaining sub rules under it.

Regards

Deepak

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: