Re: WebEx Room 70 Single CE 9.5.2 upgrade broke Camera
Are you able to revert the Webex Room 70 back to CE9.2.1 and seeing if your camera then works again?
You can do this via the web interface by going to Maintenance > System Recovery, then seleting the Software Recovery Swap, then pressing the Switch to Software button which should show the old software version.
If all is good on the old firmware version, you can then try upgrading to the latest software release again (CE9.6.1). Note: camera upgrades may also take a short while to occur after the endpoint is updated - so you may just need to be a bit more patient. (I recall one of the SX20 camera updates took around 10 minutes to complete).
Edit: Important - when updating the endpoint from CUCM, you must specify the software with the .loads extension and not the .pkg. The .pkg file does not include the software for the camera.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
AI is going to change many tasks and, as a result, many jobs.
In this podcast on artificialintelligence in the workplace, we explore how jobs may change--and what companies can do to keep workers ahead of the shift:
Check out the podcast:...
Join this featured IT Admin Control Hub session where you’ll hear about the improved Meeting diagnostics capability in Control Hub which provides IT Admins richer insights about their meetings, the participants and the quality of service. See metrics to h...
This document explains how to register a Cisco TelePresence or WebEx device to Cisco WebEx Cloud Service Using API or Local Web Interface use. This procedure is applicable for Collaboration Endpoint Software 9.8 and later. In previous versi...