cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
343
Views
0
Helpful
1
Replies

What is best QOS mechanism for VOIP in just a transport fashion?

jkeeffe
Level 2
Level 2

We are using the PA-VXB-2TE1+ board in two 7206 routers that are connected together with 100mb afstethernet. PBXs are plugged into the PA slots and we are using the 100mb FE to transport VOIP packets along with normal data IP traffic. What is the best method to set up QOS to ensure the VOIP packets have a committed bandwidth?

Would you point me to some examples of the type of QOS I should use in this case? I'm running IOS 12.2(13a).

1 Reply 1

donewald
Level 6
Level 6

Packet marking and conjestion management/avoidance for your VOIP traffic is what will do your QOS functions for you. There are a zillion ways, depending on your requirements, you can implement this. I'd start with the service policies and policy and class maps to get you what you need. Here are some links to help you on your way.

http://www.cisco.com/warp/customer/105/wantqos.html

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xe/120xe5/mqc/mqcfm/pmark.htm#xtocid2634614

Modular QOS (very good)

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800bd908.html

Hope this helps you,

Don

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: